Enable5Vout - Honeywell 7900L0P-422C20E - Hand Held Products Dolphin 7900 User Manual

On the workstation or the terminal, open the DeviceConfig.exm file in EZConfig and navigate to DeviceConfig > System >
Power Management > RS232 5V Power Out > Enable and make sure that the value is Enabled.
On the workstation:
To change the power out setting, change the Value to Disabled (on the workstation) or de-select the Enable key (on the
terminal), save the DeviceConfig.exm file, and cold boot the terminal to apply the change.
Note: For more information about the DeviceConfig Power Tool, download the Dolphin Power Tools User's Guide from
www.handheld.com.

Enable5VOut

Enable5VOut is an application on GPS terminals that modifies the power out setting between cold boots.
To use, tap Start > File Explorer > Programs > Enable5VOut
Then, tap the enable or disable button to change the setting. The change is applied immediately and remains until you manually
change it again here or the next cold boot when the terminal returns to the default setting. 5V Power ON is the default setting for
Dolphin 7900 terminals with GPS.
Note: Enable5VOut modifies the power out setting of the I/O connector temporarily. If you want the power out setting to persist
through cold boots, use DeviceConfig.
Dolphin® 7900 User's Guide
On the terminal:
.
Rev F
10/16/07
11 - 3