Cisco DMS-DMP-4300G User Manual page 92

Procedures
Procedure
Step 1
Click Wireless Configuration in the Settings list.
Tip
Step 2
Choose Enabled from the Wireless Interface list.
Each 802.11 wireless network is assigned a name to distinguish it from other networks. The technical
term for this network name is Service Set Identifier, or SSID.
Step 3
Double-click the SSID for your network in the Detected Networks table.
OR
When you do not see your SSID in the Detected Networks table, do the following.
a.
Enter in the Network SSID field the SSID for your network.
b.
Choose from the Security list the security method for your network. Its options are:
User Guide for Cisco Digital Media Player Device Manager 5.2.x
11-12
Do you see this option in DMPDM? If not, your DMP might not support it. But you can learn whether any firmware
upgrade is available that adds this feature to your DMP model.
• See our release notes — http://cisco.com/go/dms/releasenotes.
• See our compatibility information — http://cisco.com/go/dms/compatibility.
If newer firmware is available, follow the published instructions to obtain it. Then, complete the firmware upgrade
procedure in your DMPDM user guide at http://cisco.com/go/dms/dmpdm.
The nature of your Cisco DMS service contract might limit:
• Which upgrades are available to you.
• Where and how you obtain upgrades.
• Whether you must pay anything to obtain upgrades.
To learn about Cisco service contracts, see http://cisco.com/go/cscc.
•
WEP-64bit
•
WEP-128bit
•
WPA-PSK
•
WPA-EAP
Chapter 11 Configure Network Settings
OL-15764-03