Ui Reference: Elements To Define Dmp Display Dimensions - Cisco DMS-DMP-4300G User Manual

Reference
Table 10-1 Elements on the DMP Display Attributes Page (continued)
Element
HDMI Display Information
Manufacturer
Description
Version
Connector Type
Supported Standards
Related Topics
•
•

UI Reference: Elements to Define DMP Display Dimensions

Table 10-2 Elements on the DMP Display Dimensions Page
Element
DMP Display Dimensions
DMP Display X Axis
(abscissa) Center Point
(in relative units)
DMP Display Y Axis
(ordinate) Center Point
(in relative units)
User Guide for Cisco Digital Media Player Device Manager 5.2.x
10-10
Description
Shows the manufacturer name and the year in which your DMP display was manufactured.
Blank if you used any interface except HDMI to connect your DMP to its DMP display, or if
HDMI autodetection failed. You cannot edit this value.
Shows the native resolution (width and height in pixels), the scan type (progressive or
interlace), and the frame rate in Hz. The value is blank if you used any interface except HDMI
to connect your DMP to its DMP display, or if HDMI autodetection failed. You cannot edit
this value.
Shows the version number of the EDID protocol or the CEA protocol by which autodetection
occurred. Blank if you used any interface except HDMI to connect your DMP to its
DMP display, or if HDMI autodetection failed. You cannot edit this value.
Shows the connector type (HDMI or DVI) that is in use. Blank if you used any interface except
HDMI to connect your DMP to its DMP display, or if HDMI autodetection failed. You cannot
edit this value.
Shows all of the standards that your DMP display supports and shows which standard you
selected. Blank if you used any interface except HDMI to connect your DMP to its
DMP display, or if HDMI autodetection failed. You cannot edit this value.
Adjust DMP Display Attributes, page 10-5
Example Settings for DMP Display Attributes, page 10-1
Description
The absolute center point of your DMP display, as measured from left to right (on the x-axis),
in pixels. The value by default is 2048 in all DMPDM 5.2.x releases.
•
Reduce the value to move displayed content closer to the left edge.
•
Increase the value to move displayed content closer to the right edge.
The absolute center point of your DMP display, as measured from top to bottom (on the y-axis),
in pixels. The value by default is 2048 in DMPDM 5.2.3. However, in all prior 5.2.x releases, the
default value was 1835.
•
Reduce the value to move displayed content closer to the top edge.
•
Increase the value to move content closer to the bottom edge.
Chapter 10 Configure Settings for Touchscreens, Projectors, and Displays
OL-15764-03