General Precautions; Protect Against Electrostatic Discharge; Regulatory Compliance And Safety Information - Cisco DMS-DMP-4300G User Manual

Health and Safety Overview
Revised November 24, 2010
•
General Precautions, page 1-2
•
Protect Against Electrostatic Discharge, page 1-2
•
Regulatory Compliance and Safety Information, page 1-2
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work on any
Warning
equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard practices for
preventing accidents. Use the statement number provided at the end of each warning to locate its translation in the
translated safety warnings that accompanied this device.
SAVE THESE INSTRUCTIONS
• Read the installation instructions before connecting the system to the power source. Statement 1004
• The device is designed to work with TN power systems. Statement 19
• The power supply must be placed indoors. Statement 331
• This equipment is intended to be grounded. Ensure that the host is connected to an earth ground during normal use.
• When installing the unit, always make the ground connection first and disconnect it last.
Use only the Cisco-supplied combination of power cord, plug, and adapter — if any — that shipped with the equipment, or which you
ordered separately. Otherwise, if you use other such supplies, including similar supplies that Cisco might sell for use with similar
equipment, you:
• Might damage or destroy data, equipment, or other property.
• Might cause any combination of electrical shock, electrical fire, injury, or loss of life.
• Will void the warranties for Cisco equipment.
• Do not work on the system or connect or disconnect cables during periods of lightning activity.
• This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that the protective device
is rated not greater than: 120 VAC, 15A U.S. (240 VAC, 10A international)
• The plug-socket combination must be accessible at all times, because it serves as the main disconnecting device.
• To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network voltage (TNV) circuits. LAN
ports contain SELV circuits, and WAN ports contain TNV circuits. Some LAN and WAN ports both use RJ-45 connectors. Use
caution when connecting cables.
• Installation of the equipment must comply with local and national electrical codes.
• Ultimate disposal of this product should be handled according to all national laws and regulations.
OL-15764-03
C H A P T E R
User Guide for Cisco Digital Media Player Device Manager 5.2.x
1
1-1