Checklist for Deploying the Cisco Unified
Wireless IP Phone 7925G
The following topics provide an overview of procedures for adding Cisco Unified Wireless IP Phones
to your network:
•
•
•
•
Configuring a Wireless Network
Table D-1
Aironet Access Point, controller, and Ethernet switch.
When deploying the Cisco Unified Wireless IP Phone 7925G with World regulatory domain
Note
(CP-7925GW-K9), you must enable the access points for world mode (802.11d). The world model phone
gets the channels and power information from the access point.
Table D-1
Wireless Network Configuration Tasks
Activity
Check that the Cisco IOS
1.
version is the
recommended version
Configure a VLAN for
2.
voice
Cisco Unified Wireless IP Phone 7925G Administration Guide for Cisco Unified Communications Manager 7.0(1)
OL-15984-01
Configuring a Wireless Network, page D-1
Configuring QoS Policies, page D-3
Configuring the Cisco Unified Wireless IP Phone 7925G in Cisco Unified Communications
Manager, page D-4
Installing the Cisco Unified Wireless IP Phone 7925G, page D-7
explains and provides references for many of the configuration activities for the Cisco
Explanation
Under System Software, verify that Cisco
•
IOS version 12.3(8)JA or later is running on
the AP.
For the controller, use Version 4.0 and
•
Cisco IOS version 12.3(8)JX or later.
Isolate voice traffic and enable QoS by
configuring a separate voice VLAN on the
access point and network switch.
A P P E N D I X
Reference
Components of the VoIP Wireless
Network, page 2-9
Voice QoS in a Wireless Network,
page 2-12
Cisco IOS Software Configuration Guide
for Cisco Aironet Access Points, Cisco IOS
Release 12.3(8)JA
D
D-1