Chapter 6 Configuring The Phone Using The Wavelink Avalanche Server; Before You Begin - Cisco 7925G - Unified Wireless IP Phone VoIP Administration Manual

Configuring the Phone Using the Wavelink
Avalanche Server
This chapter describes the Wavelink Avalanche Management Console and how to use it to configure the
Cisco Unified Wireless IP Phone 7925G. The Cisco Unified Wireless IP Phone 7925G Configuration
Utility (CU) can be installed on the Wavelink Avalanche Management Console and used to configure a
single phone or multiple phones with common settings.
This chapter contains the following sections:
•
•
•
•
There is no support for Traffic Stream Rate Set (TSRS) or Cisco Compatible Extensions (CCX) V4.
Note
There are limitations using Wavelink because not all features are configurable. Some features are
Note
configurable only by using Cisco Unified Communications Manager Administration.

Before You Begin

Before you can use the Wavelink Avalanche Management Console to configure phones, ensure that you
have the necessary components and follow the best practices during your setup.
The following components are required for configuring the phone using the Wavelink Avalanche server:
•
•
•
•
•
Cisco Unified Wireless IP Phone 7925G Administration Guide for Cisco Unified Communications Manager 7.0(1)
OL-15984-01
Before You Begin, page 6-1
Best Practices, page 6-2
Assigning the Wavelink Server, page 6-2
Setting Up and Using the Phone CU, page 6-3
Wavelink Avalanche software
Avalanche Manager Agent
–
– Avalanche Management Console
Cisco Unified Wireless IP Phone 7925G firmware release 1.1
Cisco Unified Wireless IP Phone 7925G CU Avalanche Application Package
DHCP server (optional)
Cisco Unified Communications Manager (optional)
6
C H A P T E R
6-1