Configuring Wavelink Settings; Updating The Phone - Cisco 7925G - Unified Wireless IP Phone VoIP Administration Manual

Updating the Phone

Table 6-4
Item
Kernel Level
Configuration Level
Call Control Level
Network Services Level
Security Level
User Interface Level
Wireless Level
Audio Level
System Level

Configuring Wavelink Settings

You can configure Wavelink settings from the phone CU.
Table 6-5
Setting
Enable
Use Alternate Server
Alternate Server
Custom Name 1-4
Custom Value 1-4
Updating the Phone
When you have completed the phone configuration changes, you must export the configuration file from
the phone CU to Wavelink, and then update the phone.
The Cisco Unified Wireless IP Phone 7925G CU does not perform a complete validation of the phone
Note
configuration. If the configuration file contains an invalid setting, the phone might reject the
configuration and send an error message to the syslog.
To update the phone with the updated configuration file, perform the following steps.
Procedure
From the phone CU, select the configuration file, then choose Export to Wavelink.
Step 1
Cisco Unified Wireless IP Phone 7925G Administration Guide for Cisco Unified Communications Manager 7.0(1)
6-10
Trace Settings (continued)
Description
Operating System data.
Phone configuration data.
Cisco Unified Communications Manager data.
DHCP, TFTP, CDP data.
Application level security data.
Key strokes, softkeys, MMI data.
Channel scanning, authentication data.
RTP, SRTP, RTCP, DSP data.
Firmware, upgrade data.
Wavelink Settings
Description
Enables the Wavelink server.
Enables the use of alternate Wavelink server.
If the User Alternate Server is enabled, enter an IP address for the
alternate server.
Assign up to four attribute names to the phone to be used as
selection criteria.
Define the values for each Custom Name to be used as selection
criteria.
Chapter 6 Configuring the Phone Using the Wavelink Avalanche Server
Table 6-5 describes the Wavelink settings.
OL-15984-01