Headstock Controls - Grizzly G0554 Owner's Manual

l
M
d
e
A. Gear change Levers: used for setting
spindle speed.
b. Feed/Lead Selector Lever: used for set-
ting up power feed or threading operations in
conjunction with threading charts.
c. Lead Screw/Feed Rod Direction Lever:
Moving lever up moves carriage toward
tailstock —moving lever down moves car-
riage toward headstock when chuck is spin-
ning. do not change lever position while
machine is running.
D. Feed/Lead Selection Knob: used for set-
ting up power feed or threading operations in
conjunction with threading charts.
E. Feed Rod Lock Knob: With the knob in
the six o'clock position, the Feed/Lead
Selection Knob can be adjusted. With the
knob in the twelve o'clock position, the Feed/
Lead Selection Knob is locked in position.
F. Feed/Lead Selector Lever: used for set-
ting up power feed or threading operations in
conjunction with threading charts.
g0554 gear-head Floor lathe

Headstock controls

B
C
F
Figure 2. Control panel close-up.
A
g
h
i
J
K
G. carriage Micro Stop: used for fine adjust-
ments for
graduated to 0.001". not to Be used
With poWer Feed!
H. Emergency Stop button: stops all machine
functions. twist to reset.
i. Jog button: turns all lathe functions ON
while being pressed.
J. power Light: indicates the lathe is energized
when illuminated. Controlled by the master
power switch on the back of the cabinet.
K. coolant pump Switch: turns coolant pump
ON.
L. Speed chart: shows lever combinations for
spindle rpMs.
M. Threading chart: shows lever and knob
combinations for feed and threading opera-
tions.
repeatable carriage stops.
-7-