Replacing v-belt
To replace the v-belts on the lathe:
1.
unplug the lAthe!
2.
open the end cover door on the headstock
and the lower cover at the headstock end of
the lathe.
3.
remove the tension off the old V-belts by
loosening the motor mount hex nut (see
Figure 89).
pulley
press
⁄
"
3
4
Motor
Mount
hex
nut
Figure 89. V-belt adjustments.
-54-
Belt
Motor
pulley
4.
remove the old belts and install the new
ones. Always replace these belts in pairs.
5.
tighten the motor mount hex nut until 8 lbs.
of force applied to the belts causes approxi-
mately
⁄
" of deflection.
3
4
6.
Close end cover door and install lower cover.
then reconnect the machine to its power
source.
g0554 gear-head Floor lathe