Checking The Ima Configuration; Configuring Analog Modem Interfaces; Configure Routing Protocols On The Interface. You; Must Have Previously Enabled These Protocols As - Cisco 2620 Configuration Manual

Configuring Analog Modem Interfaces

Command
Step 13
Router(config-if)# appletalk static
cable-range 3-3
Router(config-if)# appletalk zone ZZEth
Router(config-if)# ipx network B005
Step 14
Router(config-if)# no shutdown
Step 15
Router(config-if)# Ctrl-z
Router#

Checking the IMA Configuration

After configuring the new IMA interface, you can perform the following tests to verify that the new
interface is operating correctly:
•
•
If an interface is down and you configured it as up, or if the displays indicate that the hardware is not
functioning properly, make sure that the new interface is properly connected and configured.
Configuring Analog Modem Interfaces
To configure an analog modem interface, use the configuration software provided with your router or
modem network module, if any. Otherwise, use configuration mode (manual configuration). In this
mode, you enter Cisco IOS commands at the router prompt.
Note
Before you begin, disconnect all WAN cables from the router to keep it from trying to run the AutoInstall
process. The router tries to run AutoInstall whenever you power it on if there is a WAN connection on
both ends and the router does not have a valid configuration file stored in NVRAM (for instance, when
you add a new interface). It can take several minutes for the router to determine that AutoInstall is not
connected to a remote Transmission Control Protocol/Internet Protocol (TCP/IP) host.
This section describes basic configuration, including enabling the interface and specifying IP routing.
Depending on your own requirements and the protocols you plan to route, you might also need to enter
other configuration commands.
Note
This section does not describe modem AT commands. For information about these commands, see the
AT Command Set and Register Summary for Analog Modem Network Modules publication on
Cisco.com, or Documentation CD-ROM.
Before you begin configuring the interfaces, make sure you:
•
•
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
3-26
Enter the show ima interface atm1/3 command to verify information for the specified IMA group.
Enter the show controllers atm0/ima2 command to display IMA diagnostic information for the
specified group.
Connect a console to the router.
Power on the router.
Chapter 3 Configuring with the Command-Line Interface
Purpose

Configure routing protocols on the interface. You

must have previously enabled these protocols as

part of global configuration. In this example,

AppleTalk and IPX are being configured on the

interface.
Enable the IMA group by canceling the shutdown
state.
When you finish configuring interfaces, return to
enable mode.
OL-1957-04