Asynchronous Configuration - Cisco 2620 Configuration Manual

Chapter 2 Using the Setup Command Facility
LAPB Encapsulation
lapb circuit can be either in dce/dte mode.
Choose either from (dce/dte) [dte]:
X.25 Encapsulation
x25 circuit can be either in dce/dte mode.
Choose from either dce/dte [dte]:
Enter local x25 address: 1234
We will need to map the remote x.25 station's x25 address
to the remote stations IP/IPX address
Enter remote x25 address: 4321
Do you want to map the remote machine's x25 address to IP address? [yes]:
Do you want to map the remote machine's x25 address to IPX address? [yes]:
Enter lowest 2-way channel [1]:
Enter highest 2-way channel [64]:
Enter frame window (K) [7]:
Enter Packet window (W) [2]:
Enter Packet size (must be powers of 2) [128]:
ATM-DXI Encapsulation
Enter VPI number [1]:
Enter VCI number [1]:
Do you want to map the remote machine's IP address to vpi and vci's? [yes]:
Do you want to map the remote machine's IPX address to vpi and vci's? [yes]:
SMDS Encapsulation
Enter smds address for the local interface: c141.5556.1415
We will need to map the remote smds station's address
to the remote stations IP/IPX address
Enter smds address for the remote interface: c141.5556.1414
Do you want to map the remote machine's smds address to IP address? [yes]:
Do you want to map the remote machine's smds address to IPX address? [yes]:

Asynchronous Configuration

If you select asynchronous, you see screen displays similar to the following:
Do you want to configure Serial1/1 interface? [yes]:
Enter mode (async/sync) [sync]: async
Configure IP on this interface? [yes]:
Configure IP unnumbered on this interface? [no]:
Configure LAT on this interface? [no]:
OL-1957-04
IP address for the remote interface: 2.0.0.2
IPX address for the remote interface: 40.1234.5678
IP address for the remote interface: 2.0.0.2
IPX address for the remote interface: 40.1234.5678
IP address for the remote interface: 2.0.0.2
IPX address for the remote interface: 40.1234.5678
IP address for this interface: 2.0.0.0
Subnet mask for this interface [255.0.0.0]:
Class A network is 2.0.0.0, 0 subnet bits; mask is /8
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
Configuring Interface Parameters
2-11