Configuring The Ima Interface; Step 3; Enable Routing Protocols As Required For Your; Global Configuration. This Example Uses Ip - Cisco 2620 Configuration Manual

Configuring Inverse Multiplexing for ATM Interfaces

Step 3

Router# ip routing
Router# appletalk routing
Router# ipx routing
Step 4
Router(config)# interface atm 1/0
Router(config-if)#
Step 5
Router(config-if)# ima clock line
Step 6
Router(config-if)# cablelength short 133
Step 7
Router(config-if)# loopback local

Configuring the IMA Interface

To configure the IMA interface, follow this procedure:
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
3-24
Chapter 3 Configuring with the Command-Line Interface

Enable routing protocols as required for your

global configuration. This example uses IP

routing, AppleTalk routing, and Internetwork

Packet Exchange (IPX) routing.

Enter interface configuration mode. You have
entered interface configuration mode when the
prompt changes to
Router(config-if)#.
Enter the transmit clock mode for the selected
ATM interface. The choices are internal, line, or
loop. The default is line.
For T1 interfaces only, specify the cable length
(short or long) followed by the length in feet.
You can view the acceptable cable lengths by
including the ? option after the long or short
commands.
Specify the loopback type for this ATM interface
by entering the loopback command followed by
one of the following: line, local, payload, remote.
You can view command descriptions by including
the ? option after the loopback command
.
OL-1957-04