Using The Setup Command Facility; Configuring Global Parameters - Cisco 2620 Configuration Manual

Using the setup Command Facility

Using the setup Command Facility
The setup command facility displays from your PC terminal emulation program window.
To create a basic configuration for your router, do the following:
•
•
•
Note
If you make a mistake while using the setup command facility, you can exit and run the facility again.
Press Ctrl-c, and type setup at the enable mode prompt (

Configuring Global Parameters

Step 1
Power on the router. The power switch is on the rear panel of the router, at the lower right corner, near
the power cord.
Messages will begin to appear in your terminal emulation program window.
Caution
Do not press any keys on the keyboard until the messages stop. Any keys pressed during this time are
interpreted as the first command typed when the messages stop, which might cause the router to power
off and start over. It takes a few minutes for the messages to stop.
The messages look similar to the following:
Note
System Bootstrap, Version 11.3(1)XA, PLATFORM SPECIFIC RELEASE SOFTWARE (fc1)
Copyright (c) 1998 by cisco Systems, Inc.
C2600 platform with 32768 Kbytes of main memory
rommon 1 b f
program load complete, entry point: 0x80008000, size: 0xef4e0
Self decompressing the image : ###############################################
[OK]
Notice: NVRAM invalid, possibly due to write erase.
program load complete, entry point: 0x80008000, size: 0x415b20
Self decompressing the image :
##########################################################################################
##########################################################################################
##########################################################################################
###############[OK]
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
2-2
Complete the steps in the
Complete the steps in the "Configuring Interface Parameters" section on page 2-5
router and network.
Complete the steps in the
The messages vary, depending on the Cisco IOS software release, interface modules in place in
your router, and feature set you select. The screen displays in this section are for reference only
and might not exactly reflect the messages on your console.
Restricted Rights Legend
"Configuring Global Parameters" section on page
"Completing the Configuration" section on page
Chapter 2 Using the Setup Command Facility
2-2.
2-23.
).
2600#
that apply to your
OL-1957-04