Cisco 2620 Configuration Manual page 67

Chapter 3 Configuring with the Command-Line Interface
Command
Step 12
Router(config-if)#
dce-terminal-timing-enable
Step 13
Router(config-if)# invert-txc
Step 14
Router(config-if)# nrzi-encoding
Step 15
Router(config-if)# exit
Step 16
Router(config)# Ctrl-z
Router#
Table 3-1
Timer
CTS delay
CTS drop timeout
DCD drop delay
DCD transmission start delay
2
RTS
RTS timeout
Transmit delay
OL-1957-04
Configuring Asynchronous/Synchronous Serial Network Modules or WAN Interface Cards
Half-Duplex Timer Commands
1
drop delay
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
Purpose
When a port is operating in DCE mode, the default
operation is for the DCE to send serial clock
transmit (SCT) and serial clock receive (SCR)
clock signals to the DTE, and for the DTE to
return a serial clock transmit external (SCTE)
signal to the DCE.
If the DTE does not return SCTE, enter this
command to configure the DCE port to use its own
clock signal.
Routers that use long cables might experience
high error rates when operating at higher
transmission speeds, because the clock and data
signals can shift out of phase.
If a DCE port is reporting a high number of error
packets, inverting the clock using this command
can often correct the shift.
All serial interfaces support both nonreturn to zero
(NRZ) and nonreturn to zero inverted (NRZI)
formats. NRZ is the default; NRZI is commonly
used with EIA/TIA-232 connections in IBM
environments. To enable NRZI encoding on an
interface, enter this command.
Exit back to global configuration mode.
Repeat Step 4 through Step 14 if your router has
more that one serial interface that you need to
configure.
When you finish configuring interface, return to
enable mode.
Syntax
half-duplex timer cts-delay
half-duplex timer
cts-drop-timeout
half-duplex timer
dcd-drop-delay
half-duplex timer
dcd-txstart-delay
half-duplex timer
rts-drop-delay
half-duplex timer rts-timeout
half-duplex timer
transmit-delay
Default Setting (Milliseconds)
100
5000
100
100
100
2000
0
3-7