Cisco 2620 Configuration Manual page 79

Chapter 3 Configuring with the Command-Line Interface
service-module t1 lbo none
service-module t1 linecode b8zs
no service-module t1 remote-alarm-enable
service-module t1 remote-loopback
no service-module t1 fdl
To change this configuration, enter commands in configuration mode, as described in the next section.
To view the current configuration, enter the show service-module serial slot/port command. For further
information about these commands, refer to the Cisco IOS configuration guides and command
references.
Command
Step 1
Router> enable
Password: password
Router#
Step 2
Router# configure terminal
Enter configuration commands, one per line.
End with CNTL/Z.
Router(config)#
Step 3
Router# ip routing
Router# appletalk routing
Router# ipx routing
Step 4
Router(config)# interface serial 0/0
Router(config-if)#
Step 5
Router(config-if)# ip address 172.16.74.2
255.255.255.0
Step 6
Router(config-if)# no keepalive
Router(config-if)# appletalk static
cable-range 5-5
Router(config-if)# appletalk zone ZZ
Router(config-if)# ipx network B004
Step 7
Router(config-if)# service-module t1
framing
sf
Router(config-if)# service-module t1
linecode ami
Step 8
Router(config-if)# service-module t1
timeslots 1-20 speed 64
Step 9
Router(config-if)# exit
Step 10
Router(config)# Ctrl-z
Router#
OL-1957-04
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
Configuring T1 (FT1) WAN Interface Cards
Purpose
Enter enable mode. Enter the password.
You have entered enable mode when the prompt
changes to .
Router#
Enter global configuration mode. You have
entered global configuration mode when the
prompt changes to
Router(config)#.
Enable routing protocols as required for your
global configuration. This example uses IP
routing, AppleTalk routing, and Internetwork
Packet Exchange (IPX) routing.
Enter the interface configuration mode. You have
entered interface configuration mode when the
prompt changes to
Router(config-if)#.
Assign the IP address and subnet mask to the
interface
Configure routing protocols on the interface. You
must have previously enabled these protocols as
part of global configuration. In this example,
AppleTalk and IPX are being configured on the
interface.
Enter the framing type and linecode type. In this
example, the framing type specified is
(Superframe) and the linecode specified is
If you are using fractional T1 service, enter the
time slot range and speed. In this example, the
time slot range specified is from 1 to 20, and the
speed specified is 64 kbps.
Exit back to global configuration mode.
Repeat Step 4 through Step 8 if your router has
more than one interface that you need to
configure.
When you finish configuring interfaces, return to
enable mode.
sf
.
ami
3-19