Cisco 1605-R How To Use Manual page 38

Installing a Network Module in a Cisco 3600 Series or Cisco 2600 Series Router
Figure 2-1 Installing a Network Module in a Modular Router (typical)
3
2E
W1
2W
B1
BRI
B2 NT1
SEE MANUAL BEFORE INSTALLATIO N
1
ETHERNET 1
ETHERNET 0
Step 4
Step 5
Network Module Filler Panels
If you are installing a network module in a Cisco 3600 series router, and the router is not
fully configured with modules, you must fill the open slots with slot filler panels (see
Figure 2-2) to ensure proper airflow.
2-4 Cisco WAN Interface Cards Hardware Installation Guide
Router
WO
SERIAL
2E
W1
2W
DO NOT INSTALL WAN INTERFACE
AUI
B1
CARDS WITH POWER APPLIED
EN BRI
B2 S/T
ETHERNET 1
ETHERNET 0
Module
Push the module into place until the edge connector is securely seated in the
connector on the motherboard. Ensure that each of the module's captive screws
lines up with its corresponding hole in the chassis.
Secure the captive mounting screws into the holes of the chassis using a Phillips
or flat-blade screwdriver.
2
0
WO
INPUT 100-240V AC 50/60HZ 3.0-1.5 AMPS
AUI
EN