Cisco 1605-R How To Use Manual page 33

Call Progress Tone Settings
VIC-2FXO voice interface cards are available in several versions with interfaces intended
for different geographical regions.
There are no hardware settings for connecting these voice interface cards to the public
switched telephone network. To comply with national regulatory requirements, you must
set call progress tones to the values shown in Table 1-7, using the Cisco IOS cptone
command.
To set call progress tones for a voice port, enter the following commands in global
configuration mode:
Router(config)# voice-port slot-number/subunit-number/port
Router(config-voice-port)# cptone setting
Table 1-7
Country
Australia
Canada
Denmark
Germany
Great Britain
Hong Kong
Luxembourg
Mexico
Sweden
Switzerland
Thailand
United States
Call Progress Tone Settings
Setting Compliance
australia ACA TS 002/TS 003
northamerica Industry Canada CS-03
dk –
de BAPT 223 ZV 5:July 1996
gb PD 7020:1996
hk HK Telecom CR01 and CR02
lu –
northamerica NOM-036-SCT1-1993
se SS 63 63 39
ch BAKOM 337/2.2
th PTT Subscriber Line Standards
northamerica FCC Part 68
Overview of Cisco WAN and Voice Interface Cards 1-25
Call Progress Tone Settings