Table of Contents
Advertisement
7 | English
The declared vibration total value(s) and the declared
noise emission value(s) have been measured in accordance
with a standard test method and may be used for
comparing one tool to another.
The declared vibration total value(s) and the declared
noise emission value(s) may also be used in a preliminary
assessment of exposure.
The vibration and noise emissions during actual use
of the power tool can differ from the declared values
depending on the ways in which the tool is used especially
what kind of workpiece is processed; and of the need to
identify safety measures to protect the operator that are
based on an estimation of the exposure measures in the
actual conditions of use (taking account of all parts of
the operating cycle such as the times when the tool is
switched off and when it is running idle in addition to
the trigger time).
Mounting and Operation
Action
Product Features
Delivery scope
Mounting the protection guard
Mounting the plant protector
Mounting the handle/operating
advice for right-handers
Mounting the handle/operating
advice for left-handers
Mounting the carrying strap
Battery charging and inserting
Switching on and off
Mounting the cutting line*
Line feeding
Removing the spool
Troubleshooting
Lawn Trimmer
Problem
Possible Cause
Motor refuses to start Battery discharged
Battery too hot/cold
Battery not fully inserted
Grass wrapped around the spool
Garden tool functions
On/Off switch defective
intermittently
Internal wiring of garden tool defective
Cutting head is blocked
Action
Working Advice 1
Working Advice 2
Working with the plant protector
Storage
Maintenance
Accessories
* Only use genuine parts
Line Length Adjustment
To feed the line simply tap the trimmer spool onto the
ground. The spool will release approximately 10 mm of
line to each side of the spool.
If the line has broken off close to the eyelet, tapping
should be repeated a few times in order to cut at the full
33 cm diameter.
Replacing the Line
The spool enables line loading without the need to
Figure
Page
disassemble the spool. In case the spool needs reloading
with line:
A
70
– cut off 3m of the cutting line accessory,
B
71
– align the arrows on the spool with the line feed button,
C
71
– insert the line through the eyelet marked 'line in' and
pull it through the other side. Measure an equal amount
D
72
of line on both sides,
E
73
– use the line feed button to wind the line onto the spool
by turning it in an anti-clockwise direction (see arrows
F
73
on spool) until approximately 10 cm of line is left on
each side.
G
74
H
74
I
75
J
76
K
77
L
77
Corrective Measure
Check the battery charge-control indicator and
charge the battery
Allow to cool/warm
Ensure battery is inserted correctly
Remove battery, then remove grass
Contact dealer
Contact dealer
Remove the cutting head, clear any blockages
and reinsert the cutting head
Figure
Page
M
78
N
78
O
79
P
80
Q −R
80 −81
S
82
Advertisement
Table of Contents
