Husqvarna P 524XR EFI Operator's Manual page 66

To lubricate cables
• Lubricate the 2 ends of the cables and move the
controls to the end positions.
• Attach the rubber covers on the cables after
lubrication.
• Cables with casing must be lubricated regularly to
prevent malfunction.
a) Remove the cable and hang it vertically.
b) Lubricate the cable with thin engine oil until the
oil starts to release from the bottom. Replace the
cable if the oil does not release from the bottom.
Note:
You can fill a small plastic bag with oil and seal
the plastic bag against the cable casing with tape. Let
the cable hang vertically from the bag until the next day.
To lubricate the cutting deck
Note:
The cutting decks can look different between
different models.
1. Remove the front cover.
2. Lubricate the joints and the bearings (A) with grease.
3. Lubricate with a grease gun through the grease
nipples on the cutting deck (B). Lubricate until
grease comes out of the rear side of the grease
nipple.
C112, C112X
66
C122, C122X, R137, R137X
C112, C112X, C122, C122X, R137, R137X
A
C122, C122X, R137, R137X
A
B
B
1929 - 003 - 05.12.2023