Husqvarna P 524XR EFI Operator's Manual page 38

10. Make sure that the LED above the remote control
symbol on the remote control is ON.
Note:
It is not possible to start remote control
mode if the hydraulic oil temperature is too low.
Panel - Troubleshooting for the remote
Refer to
control on page 76 .
11. Make sure that the radio signal symbol is shown in
the information center display of the remote control.
Symbols on the remote control on page 11 .
Refer to
12. Make sure that the parking brake is applied.
13. Before you operate the product with the remote
control, push the steering control to the right and
release the steering control. Make sure that the rear
end of the product moves to the side and moves
back into neutral position when the steering control
is released. Push the steering control to the left and
release the steering control. Make sure that the rear
end of the product moves to the side and moves
back into neutral position when the steering control
is released.
38
14. If the product is in a turn position before your start
to operate the product in remote control mode, you
need to align the product. If the product is in a right
turn position, push the steering control on the remote
control to the right. If the product is in a left turn
position, move the steering control on the remote
control to the left.
Note:
The operation prevented indicator comes on
and is on until the wheels of the product are aligned.
To start the engine with the remote control
1. Adjust the harness to make sure that you have a
good work position.
2. Make sure that the parking brake is applied.
1929 - 003 - 05.12.2023