Husqvarna P 524XR EFI Operator's Manual page 32

3. Press the parking brake pedal down and then
release it to disengage the parking brake.
4. Carefully press down one of the speed pedals. The
speed increases the more the pedal is pressed
down. Use pedal (A) to move forward, and pedal (B)
to reverse.
5. Release the pedal to brake. To brake harder, press
down the other speed pedal.
6. Select the cutting height. Refer to
cutting height (C112, C122, R137) on page 32 or
To adjust the cutting height (C112X, C122X, R137X)
on page 33 .
7. Push the switch for the electric lift to lower the
cutting deck. Lower the cutting deck fully until you
hear a pattering sound.
CAUTION:
minimum of 2 seconds after the cutting
deck touches the ground. This is to
32
A
B
To adjust the
Hold the switch a
make sure that the cutting deck is in float
position.
Note:
The pattering sound from the frame tunnel
does not mean that the product is defective.
8. Pull the PTO button out to engage the drive on the
cutting deck blades.
To adjust the cutting height (C112,
C122, R137)
1. Pull the switch for the electric lift to lift the cutting
deck. Lift the cutting deck fully until you hear a
pattering sound.
Note:
The pattering sound from the frame tunnel
does not mean that the product is defective.
2. Apply the parking brake.
3. Turn the ignition key to the STOP position.
4. Push and hold the lock plate in the direction of the
front of the cutting deck. Pull and lift the adjustment
lever for cutting height with your right hand. Do not
release the adjustment lever.
1929 - 003 - 05.12.2023