Husqvarna P 524XR EFI Operator's Manual page 57

5. Obey the instructions in
(C112X, C122X, R137X) on page 33 .
6. Tighten the locknuts on the lift stay when the length
of the lift stay is correct.
7. Loosen the locknut on the electric actuator. Turn the
clevis joint clockwise to increase the length of the
height adjustment rod. Increase the length of the
height adjustment rod as far as it will go, until there
is no play between the bolt and the arm. Align the
clevis joint with the hole on the frame of the cutting
deck. Install the clevis joint to the frame of the cutting
deck.
8. Tighten the locknut on the electric actuator.
9. Adjust the cutting height indicator if necessary. Refer
To adjust the cutting height indicator (C112X,
to
C122X, R137X) on page 57 .
To adjust the cutting height indicator
(C112X, C122X, R137X)
The cutting height indicator on the cutting deck show the
position of the selected cutting height.
1. Loosen the 2 screws.
2. Set the cutting height to the lowest position. Refer to
To adjust the cutting height (C112X, C122X, R137X)
on page 33 .
1929 - 003 - 05.12.2023
To adjust the cutting height
3. Adjust the cutting height indicator until the cutting
height indicator shows the lowest cutting height,
seen from the angle of the operator in the seat.
4. Tighten the 2 screws.
To replace the belt on the cutting deck
(C112, C112X, C122, C122X)
WARNING:
protective gloves.
Note:
The cutting decks can look different between
different models.
1. Remove the cutting deck. Refer to
cutting deck on page 27 .
2. Remove the 2 bolts that hold the lock bracket on the
cutting deck frame.
Risk of crush injury. Use
To remove the
57