Black & Decker Dustbuster NVC115JL Original Instructions Manual page 7

Handheld vacuum cleaner
Hide thumbs Also See for Dustbuster NVC115JL:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
While charging, the charger may become warm. This is normal
and does not indicate a problem. The appliance can be left
connected to the charger indefinitely.

WARNING! Do not charge the battery at ambient
temperatures below 10 °C or above 40 °C.
switching on and off (Fig. A, g)
• To switch the appliance on, press and hold the on/off
switch 
 1
.
• To switch the appliance off, release on/off switch
Dry pick up (nVC units Only)
• For everyday spills of dry material.

WARNING! Never pick up wet applications with these units.
Wet and dry pick up (WDC units Only)
• For everyday spills of dry material, use your appliance without
the squeegee accessory.

WARNING! Your product is designed for light spills only.
• This appliance can also be used to pick up everyday liquid
spills. Use the squeegee accessory on non-absorbent, hard
surfaces. On absorbent surfaces, such as carpet, your appliance
will pick up wet spills better without the accessory.
• For best performance on hard surface wet pickups, insert
squeegee into the bowl nozzle opening.
• For best results when using this accessory, hold the appliance
at an angle of 45° and pull it slowly towards you.
• Do not fill the bowl beyond the end of the intake chute. If
there is any liquid in the bowl, do not turn the unit upside
down, sideways, point the nozzle upward, or shake the
vac excessively.
• After picking up liquid substances clean the appliance and
filter immediately. Mold and mildew may form if the unit is not
properly cleaned after wet pickups.
• Before charging, be sure to empty all liquid contents and dry
thoroughly, to avoid damage to your appliance.
Optimising the suction force
In order to keep the suction force optimised, the filters must be
cleared regularly during use.
Emptying and cleaning the product
Removing the dust bowl and filters (Fig. h, i)

WARNING! The filters are reusable and should be
cleaned regularly.
• Press the bowl release button
straight off.
• While holding the dust bowl over a bin or sink, pull out the
filter to empty the contents of the bowl.
• To replace the dust bowl, place it back onto the handle until it
"clicks" firmly into position.

WARNING! Never use the appliance without the filters.
Optimum dust collection will only be achieved with clean filters.
Foam insert (Fig. B, J) (WDC units Only)
• Place the foam insert
13
deflector
.
14

WARNING! Never use the appliance for wet applications
without the water deflector and foam insert fitted.
Pre-filter (Fig. B, K) (nVC units Only)
The filter and pre-filter can be separated to allow
better cleaning.
1
.
2
and pull the dust bowl
into the centre of the wet/dry
• Twist the pre-filter
from the filter
11

WARNING! Never pick up wet applications with these units.
Cleaning the dust bowls and filters
• The dust bowls and filters can be washed in warm
soapy water.
• Make sure that the filters and the dust bowl are dry
before re-fitting.
Replacing the filters
The filters should be replaced every 6 to 9 months and
whenever worn or damaged.
Replacement filters are available from your
BLACK+DECKER dealer.
Maintenance
Your BLACK+DECKER corded/cordless appliance/tool has been
designed to operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation depends
upon proper tool care and regular cleaning.

WARNING! Before performing any maintenance on corded/
cordless power tools:
• Switch off and unplug the appliance/tool.
• Or switch off and remove the battery from the appliance/tool
if the appliance/tool has a separate battery pack.
• Or run the battery down completely if it is integral and then
switch off.
• Unplug the charger before cleaning it. Your charger does not
require any maintenance apart from regular cleaning.
• Regularly clean the ventilation slots in your appliance/tool/
charger using a soft brush or dry cloth.
• Regularly clean the motor housing using a damp cloth. Do not
use any abrasive or solvent-based cleaner.
Protecting the environment
Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
Products and batteries contain materials that can be
recovered or recycled reducing the demand for raw materials.
Please recycle electrical products and batteries according
to local provisions. Further information is available at
www.2helpU.com.
Technical data
3
Voltage (Vdc)
Battery
Weight (Kg)
Charger
Input Voltage (Vac)
Output Voltage (Vdc)
Current (mA)
in an anti-clockwise direction and lift
12
.
NVC115JL (H1)
NVC115W (H1)
NVC115WA (H1)
WDC115WA
(H1)
3.6
Li-Ion
0.53
SSC-040015EU/
S003BDV0500015
100 - 240
4
150
English
English
NVC215W (H1)
NVC215WA (H1)
NVC220WC (H1)
WDC215WA
(H1)
7.2
Li-Ion
0.67
SSC-080015EU/
S003BEV0800015
100 - 240
8
150
7
7

Advertisement

Table of Contents
loading

Table of Contents