Table of Contents
Advertisement
Installation Overview
Step 4
Ensure that the antennas are connected, and that ground is attached to the AP before you apply power to the
AP.
Step 5
Connect a shielded outdoor-rated Ethernet (CAT5e or better) cable between the power injector and the AP's
PoE-in connector.
Step 6
Connect the Ethernet cable to the AP PoE-In port. See
to the Access Point, on page
Connecting a DC Power Cable to the Access Point
When powering the AP with DC power, you must ensure that DC power can be conveniently removed from
the unit. The power should not be removed by disconnecting the DC power connector on the unit
If you supply DC power using your own DC supply, you need to use the DC plug kit supplied with the
AIR-ACC-KIT1= accessory kit.
Danger
Connect the unit only to a DC power source that complies with the safety extra-low voltage (SELV)
requirements in IEC 60950 based safety standards. Statement 1033
To connect a DC power cable, you need to supply these tools and material:
• Shielded outdoor-rated DC power cable (18 AWG) with outside cable diameter of 0.20 to 0.35 inch (0.51
• Adjustable or open-end wrench
• Hex crimp tool: 0.10 inch (2.54-mm)
To connect the DC power cable to the AP, follow these steps:
Procedure
Step 1
Before connecting DC power to the AP, ensure that the ground is connected to the AP. See
Access Point, on page
Step 2
Turn off all power sources to the AP, including the DC power source.
Danger
Caution
Step 3
Remove the cap from the DC connector located on the right side of the AP. Push inward toward the AP and
turn counterclockwise about a ¼ turn. The cap should dis-engage from the bayonet thread on the 2-pin DC
connector. Do not discard the cap unless you are sure the port will never need to be sealed in the future. See
the following image for the location of the DC power connector.
72.
to 0.89 cm)
66.
This unit might have more than one power supply connection. All connections must be removed
to de-energize the unit. Statement 1028
When installing DC power to the AP, always connect the AP end of the cable FIRST. When removing
the DC power connector, always disconnect the AP end of the cable LAST.
Cisco Catalyst 9124AX Series Outdoor Access Point Hardware Installation Guide
Connecting a DC Power Cable to the Access Point
Installing a CAT 5e Ethernet Cable and Gland Assembly
Grounding the
69
Advertisement
Table of Contents
