Safety Guidelines And Warnings - Cisco C9124AXE-E Installation Manual

Safety Guidelines and Warnings

Translated versions of the following safety warnings are provided in the translated safety warnings document
shipped with your AP. The translated warnings are also in the Translated Safety Warnings for Cisco Catalyst
Access Points, available on Cisco.com.
Danger IMPORTANT SAFETY INSTRUCTIONSThis warning symbol means danger. You are in a situation
that could cause bodily injury. Before you work on any equipment, be aware of the hazards involved
with electrical circuitry and be familiar with standard practices for preventing accidents. Use the
statement number provided at the end of each warning to locate its translation in the translated safety
warnings that accompanied this device. SAVE THESE INSTRUCTIONS Statement 1071
Danger This equipment is to be installed by trained and qualified personnel, as per these installation instructions. The
installer is responsible for obtaining any required local or national safety inspections of the structural integrity
of the installation by the local authority/inspection department.
Danger
Do not operate the unit near unshielded blasting caps or in an explosive environment unless the device
has been modified to be especially qualified for such use. Statement 364
Danger The cables specified in this installation guide that are used with the specified cable glands provide protection
against ingress of moisture for a Type 4/IP67 classified enclosure. If substitute cable are used, the installer
must ensure that the size (OD) of the cable meets the acceptable range allowed by the cable gland.
Danger
This equipment must be installed in restricted access locations in Norway, Finland, and Sweden. Only trained
and qualified personnel are allowed to install, replace, or service this equipment as instructed in this installation
guide.
Cisco Catalyst 9124AX Series Outdoor Access Point Hardware Installation Guide
7
C H A P T E R
89