Articulating Mount For The Ap To A Pole - Cisco C9124AXE-E Installation Manual

Articulating Mount for the AP to a Pole

Step 5
Fasten the bracket plate to the AP by using four M6 x12 mm bolts and a 10–mm box or socket wrench. Tighten
the bolts to 40 lbf-in (4.5 Nm) of torque.
Step 6 Using the 90 mm M8 long screw and the hardware supplied with the pivoting bracket, bolt the AP and bracket
plate to the wall plate mounted on the wall. See
this assembly. Do not fully tighten the assembly.
Note
Step 7
Pivot the AP as required, and then fully tighten the 90 mm M8 long screw using a 13–mm wrench.
Step 8 Proceed with installing antennas (only for external antenna models), connecting the data cables, grounding
the AP, powering, and configuring the AP.

Articulating Mount for the AP to a Pole

The optional articulating mounting kit AIR-MNT-ART1= contains a pivoting mounting bracket for both wall
and pole mounting. This kit can be used to install the AP on a pole or mast. It supports metal, wood, or
fiberglass poles from 2 to 5 inch (51 to 127mm) in diameter.
The AIR-MNT-ART1= articulating mounting kit allows for adjusting the AP position by pivoting the AP
along its vertical plane.
Figure 61: AP Pole Mounted Using the Pivoting Mounting Bracket
1
Cisco Catalyst 9124AX Series Outdoor Access Point Hardware Installation Guide
52
The AP should be mounted with the status LED on the base facing downwards.
One of four mounting holes for mounting the
AP to the bracket
Figure 58: Pivoting Wall Mounting Bracket , on page 49
3 Steel band clamps
Installation Overview
for