Table of Contents
Advertisement
Installation Overview
2
Slots for band clamps
Figure 62: Pivoting Mounting Kit with Pole Mount Clamp
1
One of four mounting holes for the AP. This is
the AP-plate end of the bracket and is fastened to
the back of the AP
2
One of four slots for band clamps.
This is the pivot bracket base plate and is fastened
to the pole.
Pole mount installation using band clamps are
shown in
Pivoting Mounting Bracket, on page
Before you begin
Ensure that you have the following materials before beginning to mount the AP to a pole:
Table 8: Materials for Mounting the AP on a Pole using AIR-MNT-ART1= Kit
Materials Required
Ground lug and screws (provided with the access point)
Pivoting mount kit and hardware
(8) M6 x 12-mm Hex-head Bolts
Adapter bracket for option horizontal mount
Two stainless steel band clamps (adjustable 2 to 5 inch (51 to 127mm)
Figure 61: AP Pole Mounted Using the
52.
Cisco Catalyst 9124AX Series Outdoor Access Point Hardware Installation Guide
Articulating Mount for the AP to a Pole
4
Pole
3
Pole mount screw clamp. It can fit poles having
a diameter of up to 2 to 3 inches (50 to 76 mm)
Supplied in the
Kit?
Yes
Yes
Yes
Yes
Yes
53
Advertisement
Table of Contents
