Connecting Data Cables; Connecting An Ethernet Cable To The Access Point; Connecting To The Rj-45 Port Using Cable Gland - Cisco Catalyst IW9167E Hardware Installation Manual

Installation Overview

Connecting Data Cables

This AP supports data connections through the Ethernet port and the Small Form-factor Pluggable (SFP) port.
If you are using the SFP port to deliver data through a fiber-optic cable, the AP must be powered by DC
power, power adapter, PoE+ power source, or a power injector.
For details on connecting to Ethernet port, see
41.
For details on connecting to SFP port, see

Connecting an Ethernet Cable to the Access Point

Connect an Ethernet cable to the access point by using a cable gland or an M12-RJ45 adapter.

Connecting to the RJ-45 Port Using Cable Gland

Follow these steps to connect to the RJ-45 port using cable gland:
SUMMARY STEPS
1. Disassemble PG13 cable gland and slide parts over RJ-45 cable in the order shown in the following figure:
2. Plug the RJ-45 cable into the RJ-45 connector in the chassis.
3. Thread the PG13 body (with gasket) into the chassis.
4. Insert the grommet into the ferrule, and press it into the PG13 body.
5. Tighten the clamp nut onto the PG13 body until the grommet compresses onto the RJ-45 cable.
DETAILED STEPS
Step 1 Disassemble PG13 cable gland and slide parts over RJ-45 cable in the order shown in the following figure:
Connecting an Ethernet Cable to the Access Point, on page
Connecting to the SFP Port of the Access Point, on page
Cisco Catalyst IW9167E Heavy Duty Access Point Hardware Installation Guide

Connecting Data Cables

44.
41