Makita VC010G Instruction Manual page 20

Installing cyclone attachment
1. Turn the cuff on the hose counterclockwise and
remove the hose, pipe grip, and aluminum pipe from the
appliance.
2
3
4
Fig.47
► 1. Cuff 2. Hose 3. Pipe grip 4. Aluminum pipe
2. Turn the side of the stopper on the cyclone attach-
ment upward, aligning the stopper with the groove
of the suction inlet. Lock the stopper by inserting the
cyclone attachment until it clicks. Pull the cyclone
attachment lightly to make sure it will not be removed.
Install the straight pipe with the same procedure as the
cyclone attachment.
1
2
Fig.48
► 1. Grip for cyclone attachment 2. Suction inlet
3. Cyclone attachment 4. Straight pipe for cyclone
attachment 5. Stopper 6. Locking button
1
6
5
3
3. Install the cyclone attachment on the appliance,
and then turn the cuff on the hose clockwise to fix it.
Fig.49
Disposing of dust
When dust has accumulated up to the full line of the
dust case, follow the procedure below and dispose of
the dust.
1. Hold the dust case firmly, press and hold the two
buttons, and remove the dust case.
Fig.50
► 1. Full line 2. Dust case 3. Button (two locations)
4
4. Mesh filter
2.
Dispose of the dust inside the dust case and
remove any dust and powder adhered to the surface of
the mesh filter.
20 ENGLISH
1 4
2
①
3
②