GE PR06DSATB Series Owner's Manual page 7

Installation Instructions
Installation Location
Planning the location of the water heater within the RV:
• The location of this water heater within the RV should be considered before constructing the sidewalls of
the trailer or vehicle. Make sure to choose a location with adequate clearance and depth to accommodate
this water heater design.
• Do not install the water heater such that the vent can be covered or blocked when any door on the RV is
opened.
• Do not install the water heater to where the vent terminates below a slide out. This appliance is not to be
installed under any overhang.
• The tank of the water heater must be supported such that it is level with bottom of the sidewall cutout.
• It is recommended to provide adequate clearance and access to the rear water connections of the water
heater for easy servicing and winterizing.
• If the water heater is installed where a plumbing connection or tank leakage could damage the
surrounding area, it is recommended to install a drain pan that is plumbed to drain outside of the RV.
• Do not install the water heater directly onto to carpeting. If required, place a metal or wooden shield
directly under the entire area of the water heater.
Installing the Water Heater
1. After the sidewalls of the RV have been constructed, cut the required opening size for the water heater per
the table below.
6 Gallon Dual Fuel
PR06DSATB*
10 Gallon Dual Fuel
PR10DSATB*
Holes for securing
water heater to frame
Cutout Dimensions
Height
12.75 in (31.75 cm) 12.75 in (31.75 cm)
12.75 in (31.75 cm) 12.75 in (31.75 cm)
Install into opening.
Depth
Width
18.5 in (47 cm)
26.25 in (66.7 cm)
7