GE PR06DSATB Series Owner's Manual page 15

Installation Instructions
Installing the Control Switch (continued)
1. Cut the appropriate size hole to install the switch. Make sure to allow enough room to mount the switch
after completing the electrical connections in step 2.
2. Make the 12 VDC electrical connections:
Note: The front of the control switch indicates which switch controls each heating option (gas or
electric). The lightening bolt indicates electric heating. The flame indicates gas heating. It is
critical to wire the correctly for each heating option.
A. Install the black +12 VDC wire routed from the battery onto the double spade connector on the
back of the electric heating switch
B. Install the white wire routed from the water heater to the single spade connector on the back of the
electric heating switch
C. Install the orange wire routed from the water heater to the top spade connector on the back of the
gas heating switch.
D. Install the blue wire routed from the water heater to the top spade connector on the back of the red
indicator light.
E. Install a ground wire on the bottom spade connector on the back of the red indicator light and
connect to an appropriate grounding location.
3. Install the control switch into the open cutout making sure not to disconnect or pinch any wires.
4. Mount the control switch using four screws or appropriate fasteners in the locations shown.
D
C
E
A
B
15