Table of Contents
Advertisement
SECTION 6: MAINTENANCE
To reduce risk of shock or
accidental startup, always
disconnect machine from
power before adjustments,
maintenance, or service.
Schedule
For optimum performance from this machine, this
maintenance schedule must be strictly followed.
Ongoing
To minimize your risk of injury and maintain proper
machine operation, shut down the machine imme-
diately if you ever observe any of the items below,
and fix the problem before continuing operations:
•
Clean machine and protect unpainted cast-
iron surfaces.
Lubricate feed roller bushings (Page 32).
•
•
Tighten loose mounting bolts.
•
Check/sharpen/replace damaged or worn
inserts (Page 28).
•
Check/repair/replace worn or damaged wires.
•
Resolve any other unsafe condition.
Every 40 Hours of Operation:
•
Clean cutterhead and inspect inserts (Page
28).
•
Lubricate table columns and leadscrews
(Page 34).
Inspect/clean anti-kickback fingers (Page 34).
•
Every 160 Hours of Operation:
•
Check/tension/replace V-belts (Page 38).
•
Clean/vacuum dust buildup from inside cabi-
net and off motor.
•
Lubricate table height chain and sprockets
(Page 32).
•
Lubricate drive chain and sprockets (Page 33).
Yearly:
•
Change gearbox oil (Page 33).
Model G0454ZX (Mfd. Since 06/23)
Cleaning &
Protecting
Cleaning the Model G0454ZX is relatively easy.
Vacuum excess wood chips and sawdust, and
wipe off the remaining dust with a dry cloth. If any
resin has built up, use a resin dissolving cleaner
to remove it.
Protect the unpainted cast iron table by wiping
it clean after every use—this ensures moisture
from wood dust does not remain on bare metal
surfaces. Keep the table rust-free with regular
applications of products like SLIPIT
30 for more details).
Lubrication
NOTICE
Failure to follow reasonable lubrication
practices as instructed in this manual for
your machine could lead to premature fail-
ure of components and void the warranty.
This planer features bearings that are lubricated
and sealed at the factory. These bearing do not
require any further attention unless they need
to be replaced. If a bearing fails, your planer will
probably develop a noticeable rumble or vibration,
which will increase when the machine is under a
load. The bearings are standard sizes and can be
replaced through Grizzly.
Follow the maintenance schedule on this page
and the procedures beginning on Page 32 to
properly lubricate the other planer components,
which are essential for long life and trouble-free
operation of the planer.
(see Page
®
-31-
Advertisement
Table of Contents
