Table of Contents
Advertisement
Positioning Chip
Deflector
Chip Deflector Gap Setting ..................
When properly distanced from the cutterhead, the
chip deflector directs the chips into the dust hood,
and keeps them from falling onto the outfeed roller
and being pressed into the workpiece.
Tools Needed:
Wrench or Socket 10, 13mm .......................1 Ea.
To adjust chip deflector gap:
1.
DISCONNECT MACHINE FROM POWER!
2.
Remove dust hood, top cover, and belt cover.
3.
Use cutterhead pulley to rotate cutterhead
until a knife/insert reaches closest distance
to chip deflector (see Figure below), then
measure distance between knife/insert and
chip deflector.
Chip
Deflector
Figure 46. Example of chip deflector and
mounting hardware.
4.
If distance measured in Step 3 is not equal to
correct chip deflector gap setting, then loosen
flange bolts (see Figure 46) that secure chip
deflector and adjust gap to correct setting.
5.
Re-tighten flange bolts, then replace belt
cover, top cover, and dust port.
Model G0454ZX (Mfd. Since 06/23)
Calibrating Table
⁄
''–
⁄
''
Although correctly set at the factory, the table
1
1
16
8
height scale can be adjusted for accuracy if
necessary.
Items Needed
Phillips Head Screwdriver #2 ............................ 1
Scrap Piece of Stock ......................................... 1
Calipers ............................................................. 1
Qty
To calibrate table height scale:
1.
Plane a scrap piece of stock until it is flat and
of even thickness along its length.
Note: Turn board over between each pass.
2.
Use calipers to measure board thickness.
3.
If there is a discrepancy between board
thickness and reading on table height scale,
loosen screws shown in Figure 47, adjust
scale as necessary, then tighten screws.
x 5
x 2
Figure 47. Location of adjustment screws for
Height Scale
table height scale.
Qty
-43-
Advertisement
Table of Contents
