Section 6: Maintenance - Grizzly T33307 Owner's Manual

SECTION 6: MAINTENANCE

Always DISCONNECT BATTERY
from tool before
adjusting, or doing maintenance to
reduce the risk of injury due to tool
starting accidentally.
For optimum performance from this tool,
routinely check the condition of the following
items and repair or replace as necessary.
• Loose bolts.
• Damaged/dull knives.
• Worn or damaged wires.
• Damaged belt.
• Any other unsafe condition.
Cleaning
Use a brush and a shop vacuum to remove
wood chips and dust from the tool, par-
ticularly from around the tool holder and
motor vents. Never blow off the tool with
compressed air, as this could force debris
more deeply into the motor vents.
-18
-
servicing,
The Model T33307 cutterhead has two
reversible knives. If damage occurs to the
knives, they will either need to be reversed
or replaced.
If one knife is dull or damaged, reverse
or replace both knives as a set. DO NOT
attempt to sharpen the knives.
Items Needed
Open-End Wrench 8mm (Tool Holder) ..... 1
Flat Head Screwdriver
Protective Gloves ................................1 Pr.
Replacement Knives (#PT33307037-6) ... 2
Straightedge 6" ......................................... 1
Hex Wrench 2.5mm (Tool Holder) ............ 1
To reverse/replace knives:
1. DISCONNECT
2. Remove tool holder to access 8mm
Reversing/Replacing
Knives
TOOL!
wrench and 2.5mm hex wrench (see
Figure 24).
Tool Holder
Figure 24. Tool holder location.
Model T33307 (Mfd. Since 06/22)
Qty.
⁄ " ......................... 1
1
4
BATTERY FROM