Honeywell HN300401 Series User Manual page 86

I/O: The I/O tab displays the device I/O settings. Only the on-board I/O (i.e., USB I/O) is
supported and network I/O is not supported. Click the edit icon to enable editing.
• You can change the Name of a Inputs and can change the Level to NO (Normally Open)
or NC (Normally Closed).
The output behavior is set using Output. You can change the Output name, Trigger
•
source (i.e., the input source triggering the output), and VMD (i.e., the camera motion
triggering the output). l
• You can manually trigger the output by clicking Test Output on MPC.
Click Save to save the changes on MAXPRO Cloud.
Storage: Displays the total capacity of the hard disks and the used space.
5. Click Save.
Apply camera level settings.
1. Click and select Customers.
2. Select the customer and the site.
3. Click Devices and select a controller from the drop-down list. The camera list of the 30
Series NVR is displayed.
Figure 6-59 Devices
Cameras with Disabled status on MPC is deleted on 30 Series
Note
NVR.
4. Select a camera and click edit to change the camera settings. Apply the Configure tab
settings.
MPC will change the decode of cameras as H.264 when add
Note
cameras with decode H.265.
Enable: This setting can be used to enable / disable a camera. If you disable a camera on
MPC, the camera is deleted on 30 Series NVR, too.
Settings
69