Table of Contents
Advertisement
Cleanup
The unpainted surfaces of your machine are
coated with a heavy-duty rust preventative that
prevents corrosion during shipment and storage.
This rust preventative works extremely well, but it
will take a little time to clean.
Be patient and do a thorough job cleaning your
machine. The time you spend doing this now will
give you a better appreciation for the proper care
of your machine's unpainted surfaces.
There are many ways to remove this rust preven-
tative, but the following steps work well in a wide
variety of situations. Always follow the manufac-
turer's instructions with any cleaning product you
use and make sure you work in a well-ventilated
area to minimize exposure to toxic fumes.
Before cleaning, gather the following:
•
Disposable rags
•
Cleaner/degreaser (WD•40 works well)
•
Safety glasses & disposable gloves
•
Plastic paint scraper (optional)
Basic steps for removing rust preventative:
1.
Put on safety glasses.
2.
Coat the rust preventative with a liberal
amount of cleaner/degreaser, then let it soak
for 5–10 minutes.
3.
Wipe off the surfaces. If your cleaner/degreas-
er is effective, the rust preventative will wipe
off easily. If you have a plastic paint scraper,
scrape off as much as you can first, then wipe
off the rest with the rag.
4.
Repeat Steps 2–3 as necessary until clean,
then coat all unpainted surfaces with a quality
metal protectant to prevent rust.
NOTICE
Avoid chlorine-based solvents, such as
acetone or brake parts cleaner, that may
damage painted surfaces.
Model T10718 (Mfg. Since 1/13)
Cleaning Blocks
The clamping fingers and bending blocks
(Figure 1) are coated with rust preventative that
must be removed before beginning operation.
Bending
Block
Figure 1. Bending finger and clamping block
removed for cleaning.
Although the rust preventative was applied only
to the visible surfaces of the blocks, some may
have worked in between and underneath them.
We recommend that you remove all of the blocks
to thoroughly clean them.
If you do remove the blocks, properly align them
as described in the Aligning Fingers & Blocks
subsection on Page 17 after re-installing.
Clamping
Finger
-9-
Advertisement
Table of Contents
