Grizzly T10096 Instructions Manual

Inventory
The Model T10096 taper attachment was carefully
packed when it left our warehouse. If you discover
it is damaged after you have signed for delivery,
please immediately call Customer Service at
(570) 546-9663 for advice.
Save containers and packing materials for possible
inspection by the carrier or its agent. Otherwise,
filing a freight claim can be difficult.
When you are completely satisfied with the condi-
tion of your shipment, inventory the contents.
Inventory
(Figure 1)
A. Taper Attachment Assembly ...................... 1
B. Roll Pins 8.5 x 40mm ................................. 2
C. Cap Screws M10-1.5 x 40mm .................... 4
D. Deadman Arm and Deadman .................... 1
B C
A
Figure 1. Model T10096 inventory.
COPYRIGHT © FEBRUARY, 2015 BY GRIZZLY INDUSTRIAL, INC., REVISED SEPTEMBER, 2015 (MN)
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
TAPER ATTACHMENT FOR
G0509 & G0509G LATHE
The Model T10096 taper attachment is designed
to fit onto Model G0509 and G0509G lathes (see
Figure
the maximum angle range is 0° to 8°.
Qty
This attachment is intended to be a permanent
installation. Installation will take approximately 2.5
hours and require the following:
D
Needed Items
Hex Wrenches (3, 4, 5, 6, and 8mm) ...........1 Ea
Drill Bit (Q) ......................................................... 1
Drill Bit (8mm) .................................................... 1
Drill (
Oil Can with Pressure Tip ................................. 1
Dial Indicator with Magnetic Base ..................... 1
Phillips Screwdriver (#2) .................................... 1
Hammer ............................................................. 1
M10 x 1.5 Tap ................................................... 1
Tap Wrench ....................................................... 1
⁄
25
#MN17232 PRINTED IN CHINA
MODEL T10096
INSTRUCTIONS
Wear safety glasses during
the entire setup process!
2
). The maximum stroke is 300mm and
Figure 2. Model G0509G lathe.
⁄ ") ............................................................. 1
3
8
" or 10mm Transfer Punch ........................... 1
64
Qty