Makita ADP12 Instruction Manual page 8

TROUBLESHOOTING
Before asking for repairs, check the following points.
State of Probable cause
abnormality (malfunction)
The connector The remaining bat-
cannot turn on. tery capacity is low.
The lamp of
Battery cartridge
status does not
is installed
light.
improperly.
The status lamp The tool is
blinks in red. installed
improperly.
Battery cartridge
is installed
improperly.
The connector The signal is
cannot establish weak.
the connec-
tion with the
Bluetooth con-
smartphone/
nection of the
tablet.
smartphone/tab-
let is disabled.
The USB con- The USB cable
nection with PC is not plugged in
does not work. properly.
The cable is
broken.
The USB
cable is out of
specification.
If the trouble cannot be solved even after taking the
above measures, the connector may be defective.
Please contact Makita Authorized Service Centers.
MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
NOTICE:
Do not wash the connector with water.
Risk of malfunction.
NOTICE:
From time to time wipe off the outside
of this connector using a cloth dampened in
soapy water.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
Remedy
Charge the battery
cartridge.
Remove the battery
cartridge once.
Re-install the battery
cartridge as described
in this manual.
Remove the tool once.
Re-install the tool
as described in this
manual.
Remove the battery
cartridge once.
Re-install the battery
cartridge as described
in this manual.
Put the smartphone/
tablet closer to the
connector.
Activate the Bluetooth
connection of the
smartphone/tablet.
Make sure that the USB
cable is plugged into
the USB port firmly.
Use another USB
cable.
Use the USB cable
which is specified in
this manual. Refer
to the section for
specifications.
8 ENGLISH