Makita ADP12 Instruction Manual page 4

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Applicable battery cartridge
Dimensions
(L x W x H)
(Without the battery and the tool)
Net weight
(Without the battery and the tool)
Bluetooth
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Some of the battery cartridges listed above may not be available depending on your region of residence.
Applicable USB cable
Use a USB cable that matches the USB Type-C
terminal.
We recommend a USB cable with a shield, USB-IF
approval, and a length of up to about 1.8 m.
Applicable cord connected power
source
Whether the cord connected power source is applicable
or not depends on what the tool to be used with. Refer
to the specification of the tool.
Notification about non-compatible
tools
Some tools are not compatible with this connector.
Please refer to the web manual in the figure for specific
model numbers.
App web manual for ADP12
► Fig.1
Symbols
The followings show the symbols which may be used
for the equipment. Be sure that you understand their
meaning before use.
Read the instruction manual.
Indoor use only.
Bluetooth® version
Transmission range
Frequency band
Maximum radio-frequency power
BL4020 / BL4025 / BL4040 / BL4050F / BL4080F
98 mm x 85 mm x 55 mm
5.1 (Bluetooth low energy)
Approximately 10 m
2,402 MHz - 2,480 MHz
Only for EU countries
Due to the presence of hazardous com-
ponents in the equipment, waste electrical
and electronic equipment, accumulators
and batteries may have a negative impact
on the environment and human health.
Ni-MH
Li-ion
Do not dispose of electrical and electronic
appliances or batteries with household waste!
In accordance with the European Directive on
waste electrical and electronic equipment and on
accumulators and batteries and waste accumu-
lators and batteries, as well as their adaptation to
national law, waste electrical equipment, batter-
ies and accumulators should be stored sepa-
rately and delivered to a separate collection point
for municipal waste, operating in accordance with
the regulations on environmental protection.
This is indicated by the symbol of the crossed-
out wheeled bin placed on the equipment.
Declarations of Conformity
For European countries only
The Declarations of conformity are included in Annex A
to this instruction manual.
ICES (IC) standard
For Canada only
CAN ICES-003(B)/NMB-003(B)
This device contains licence-exempt transmitter(s)/receiv-
er(s) that comply with Innovation, Science and Economic
Development Canada's licence-exempt RSS(s).
Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, includ-
ing interference that may cause undesired opera-
tion of the device.
This equipment complies with ISED radiation expo-
sure limits set forth for an uncontrolled environment
and meets RSS-102 of the ISED radio frequency (RF)
Exposure rules as this equipment has very low levels of
RF energy.
4 ENGLISH
ADP12
0.17 kg
0.11 dBm (EIRP)