Yamaha TransAcoustic TA3 Owner's Manual page 66

Message
* When an operation (such as saving or data transfer) is in progress, the display shows a sequence of flashing dashes.
* Press any button to exit from these message displays.
66
TA3 SH3 SC3 Owner's Manual
Communication with the USB flash drive has been shut down because of overcurrent to the USB flash drive.
Disconnect the USB flash drive from the [USB TO DEVICE] terminal, and then turn on the power of the instrument
again.
Communication with the USB flash drive has failed. Remove the USB flash drive and make the connection again.
If the message appears even when the USB flash drive is connected properly, try using another USB flash drive.
This USB flash drive is not supported on this instrument, or too many USB flash drives may have been connected.
Refer to "Using USB Flash Drives" (page 55) for information on the USB flash drive connection.
The instrument is in standby for connection to an access point by WPS (page 62). While this message is shown,
you cannot operate the instrument.
A malfunction occurred in the instrument while it was standing by for connection to an access point by WPS
(page 62). Reconnect the USB wireless LAN adaptor (UD-WL01; sold separately) to the instrument and try to
connect to the access point by WPS again.
Description