2.4G / 5G
(Wireless LAN)
DMZ
LED on Connector
WAN2 / P6
(2)
LAN P1~P5
The port "WAN2 / P6" is switchable. It can be used for LAN connection or WAN
connection according to the settings configured in WUI.
Off
On
Off
Blinking
On
Off
Blinking
Left LED
On
Off
Blinking
Right LED
On
Off
Left LED
On
Off
Blinking
Right LED
On
Off
[Firewall] > [General Setup])
Web Content Filter is inactive
2.4G: 2.4GHz Access Point is active
5G: 5GHz Access Point is active
Wireless Access point is inactive
2.4GHz/5GHz LED will blink slowly when
transmitting over that interface
ACT & WLAN LEDs blink rapidly when WPS is
ready for WPS clients to connect. After 2
minutes, the router will disable WPS pairing
mode
DMZ Port is enabled
DMZ Port is not enabled
Data is being transmitted through DMZ Port
Ethernet WAN (RJ45) is connected
Ethernet WAN is disconnected
Data is transmitting (sending/receiving)
The port is connected with 1000Mbps
The port is connected with 10/100Mbps
Ethernet LAN (RJ45) is connected
Ethernet LAN is disconnected
Data is transmitting (sending/receiving)
The port is connected with 1000Mbps
The port is connected with 10/100Mbps
3