Draytek Vigor2866ac Quick Start Manual page 13

LED
The port "WAN2 / P6" is switchable. It can be used for LAN connection or WAN
connection according to the settings configured in WUI.
Interface
Wireless LAN
ON/OFF/WPS
Factory Reset
USB1~2
WAN2 / P6
LAN P1-P5
Phone 1/2
DSL
PWR
ON/OFF
Off The port is connected with 10/100Mbps
Description
Wireless band will be switched on/off in a cycle:
⚫ 2.4G (On) and 5G (On) – Default state.
⚫ 2.4G (Off) and 5G (On) – press and release the button
once.
⚫ 2.4G (On) and 5G (Off) – press and release the button
twice.
⚫ 2.4G (Off) and 5G (Off) – press and release the button
three times.
When WPS is enabled in the router's web interface, press
this button for more than 2seconds to enable WPS pairing
mode.
Restore the default settings. Usage: Turn on the router (ACT
LED is blinking). Press gently and hold for more than 5
seconds. When the ACT LED blinks rapidly, release the
button and the router will restart with its factory default
configuration.
Connector for a USB 3G/4G modem, storage, printer or USB
Thermometer
RJ-45 Gigabit Ethernet connector for WAN modem / router
RJ-45 Gigabit Ethernet connectors for local network devices
RJ-11 connectors for VoIP usage with analogue telephones
RJ-11 connector for ADSL or VDSL line
RP-SMA Connector for installing WLAN antennas
Connector for the power adapter
Power Switch. Turns the unit on or off
7