Vigor2866Vac - Draytek Vigor2866ac Quick Start Manual

2 . 2 V i g o r 2 8 6 6
2 . 2 V i g o r 2 8 6
LED
ACT
WAN2
QoS
USB
DSL
Phone1/2
2.4G/5G
(Wireless LAN)
LED on Connector
Left
WAN2
LED
/ P6
Right
LED
Left
LAN
LED
P1~P5
Right
V a c
6 V a c
Status Explanation
Off The router is powered off
Blinking The router is ready and operating normally
On Internet connection is ready for use
Off Internet connection is offline
Blinking Data is being transmitted over WAN2
On Quality of Service is active
Off Quality of Service is inactive
On USB device is connected and ready for use
Off No USB device is connected
Blinking Data is being transmitted over USB
On DSL connection synchronised
Blinking Slowly: DSL connection not currently
synchronising or not detected
Quickly: DSL connection is synchronising
On The phone connected to this port is off-hook
Off The phone connected to this port is on-hook
Blinking A phone call is incoming
2.4G: 2.4GHz Access Point is active
On
5G: 5GHz Access Point is active
Off Wireless Access point is inactive
2.4GHz/5GHz LED will blink slowly when
Blinking
transmitting over that interface
ACT & WLAN LEDs blink rapidly when WPS is
ready for WPS clients to connect. After 2
minutes, the router will disable WPS pairing
mode
On Ethernet WAN (RJ45) is connected
Off Ethernet WAN is disconnected
Blinking Data is transmitting (sending/receiving)
On The port is connected with 1000Mbps
Off The port is connected with 10/100Mbps
On Ethernet LAN (RJ45) is connected
Off Ethernet LAN is disconnected
Blinking Data is transmitting (sending/receiving)
On The port is connected with 1000Mbps
6