Toshiba VFNC3-2001P Instruction Manual page 165

efesotomasyon.com -Toshiba inverter,drive,servo,plc
Title
Free unit display

scale
* The  converts the following parameter settings:
• Free unit Frequency monitor display
6.18.4 Changing the steps in which the value increment
 : Free step 1 (1-step rotation of setting dial)
• Function
It is possible to change the step width changed at panel frequency setting.
This function is useful when only running with frequencies of intervals of 1 Hz, 5 Hz, and 10 Hz units.
Note 1: The settings of these parameters have no effect when the free unit selection (  ) is enabled.
Note 2: Set  to other than 0. When increasing the frequency by rotating the setting dial and if 
(max. frequency) is exceeded by rotating 1 step more, be careful as the  alarm displays before
this happens and the frequency cannot be increased beyond this point.
Similarly, when rating the settings dial to lower the frequency, if the rotating 1 step more lowers it
below  (lower limit frequency), the  alarm displays before this happens and the frequency
cannot be lowered beyond this point.
Title
Free step (1-step rotation of setting

dial)
Operation example
 = 0.00 (disabled)
By rotating the setting dial 1 step, the panel frequency command value changes only 0.1 Hz.
When  = 10.00 (Hz) is set
Rotating the setting dial 1 step changes the panel frequency command value in 10.00 Hz increments, from
0.00 up to 60.00 (Hz).
Function
0.00: Disabled (display of frequency)
0.01-200.0
Frequency-related parameters
Function
F-61
Adjustment range
Operation frequency command, Operation
frequency, PID feedback, Frequency command
value After correction, Operation frequency
command at trip
 ,  ,  ,  ,  ∼  ,
 ,  ,  ,  ,  ,
 ,  ,  ,  ,  ,
 ,  ,  ,  ,
 ∼  ,  ,  , 
Adjustment range
0.00: Disabled
0.01-  (Hz)
E6581595
Default setting
0.00
6
Default setting
0.00