Black & Decker PR100 Use And Care Manual page 41

PROBLEM
Display flashes 3
blinking bars but timer
doesn't start
Display flashes "C5" and
the pressure cooker
shuts down
Display remains blank
after connecting the
power cord
All LEDs flash C1 code
with a code
C2 code
appearing on
screen
C5 code
C6 code
Rice half cooked
or too hard
Rice too soft
POSSIBLE CAUSE
Working Pressure release
pressure valve is not
isn't reached in the seal
inside during position
preheating
Rubber gasket
cycle
is not in place
Red interlock
pin with rubber
retainer ring on
bottom of lid is
not in place
Overheating is detected on the
cooking bowl
Bad power connection or no
power
Appliance electrical issue
Faulty temperature sensor
(cannot be detected)
Faulty temperature sensor (short
circuited)
Temperature is too high because
cooking bowl is not in the
pressure cooker
Temperature is too high because
there is no water in cooking
bowl
Faulty pressure sensor
Not enough water
Lid was opened prematurely
Too much water
41
SOLUTION
Check if pressure release
value is turned to the seal
position
Install the rubber gasket
correctly
Check that red interlock
pin is installed with the
rubber retainer ring on
the bottom of lid
Stop the program, use
the pressure release valve
to reduce the internal
pressure and check if the
food at the bottom of the
cooking bowl is burnt
Inspect the power
cord to ensure a good
connection, check that
the power outlet is active
Contact the consumer
service team
Contact the consumer
service team
Adjust dry rice and water
ratio according to the
recipe
After cooking cycle is
complete, leave the lid on
for 5 more minutes
Adjust dry rice and water
ratio according to the
recipe