Functional Description - Makita 7104L Instruction Manual

FUNCTIONAL
DESCRIPTION
1
1. Wing bolt
2. Stopper pole
3. Stopper
2
1. Lock-off button
2. Switch trigger
ASSEMBLY
1
4
2
1. Adjusting screw
2. Chain bar
3. Chain cover
4. Hex bolt
CAUTION:
• Always be sure that the tool is switched off and unplugged before
adjusting or checking function on the tool.
Adjusting depth of cut
005999
Loosen the wing bolt on the stopper. Move the stopper to the desired position
2
and tighten the wing bolt. When tightened, the tip of the wing bolts should con-
tact the flat surface of the stopper pole. The numbers indicated on the stopper
3
pole are in cm units (3 mm per graduation).
Switch action
006300
CAUTION:
1
• Before plugging in the tool, always check to see that the switch trigger
actuates properly and returns to the "OFF" position when released.
To prevent the switch trigger from being accidentally pulled, a lock-off button is
provided. To start the tool, push in the lock-off button and pull the switch trig-
ger. Release the switch trigger to stop.
CAUTION:
• Always be sure that the tool is switched off and unplugged before
carrying out any work on the tool.
Installing or removing cutter chain
006290
WARNING:
• Always be sure that the tool is switched off and unplugged before
installing or removing the cutter chain.
• Always close the chain cover after installing, removing or adjusting the
cutter chain.
3
To install the cutter chain, open the chain cover. Loosen the hex bolt securing
the chain bar and the adjusting screw.
5