Functional Description - Makita 7104L Instruction Manual

operation to keep it from falling off and
possibly causing injury.
13. Don't abuse cord. Never yank cord to
disconnect it from the receptacle. Keep cord
away from heat, oil, water and sharp edges.
SAVE THESE INSTRUCTIONS.

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Adjusting depth of cut
1
005999
Loosen the wing bolt on the stopper. Move the stopper to
the desired position and tighten the wing bolt. When
tightened, the tip of the wing bolts should contact the flat
surface of the stopper pole. The numbers indicated on
the stopper pole are in cm units (3 mm (1/8") per
graduation).
Switch action
1
2
008558
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and
returns to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
A hole is provided in the handle for insertion of a padlock
to lock the tool off.
1. Wing bolt
2
2. Stopper pole
3. Stopper
3
1. Hole for padlock
2. Switch trigger
WARNING:
Do not use a lock with a shank or cable any
•
smaller than 2.5 mm(0.1") in daimeter.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Installing or removing cutter chain
1
2
3
008561
WARNING:
Always be sure that the tool is switched off and
•
unplugged before installing or removing
cutter chain.
Always close the chain cover after installing,
•
removing or adjusting the cutter chain.
To install the cutter chain, open the chain cover. Loosen
the hex bolt securing the chain bar and the adjusting
screw.
Orient the cutters in the direction of the arrow on the tool
(rotational direction). Attach the cutter chain to the
sprocket first and then to the chain bar. Semi-tighten the
hex bolt.
1
2
3
008562
Turn the adjusting screw to increase the tension on the
cutter chain. Pull the middle of the cutter chain lightly.
When there is a clearance of approx. 5 - 6 mm (3/16" -
1/4") between the chain bar and the cutter chain, the
tension on the cutter chain is adequate.
4
1. Adjusting screw
2. Hex bolt
3. Chain bar
4. Chain cover
4
the
1. Arrow
2. Sprocket
3. Hex bolt