Makita 7104L Instruction Manual page 6

1
2
3
1. Arrow
2. Sprocket
3. Hex bolt
5-6mm
3-8mm
2
3
1. Lever (A)
2. Vise lever
3. Rear vise
1
1. Setting handle
2. Front vise
6
Orient the cutters in the direction of the arrow on the tool (rotational direction).
006291
Attach the cutter chain to the sprocket first and then to the chain bar. Semi-
tighten the hex bolt.
Turn the adjusting screw to increase the tension on the cutter chain. Pull the
006003
middle of the cutter chain lightly. When there is a clearance of approx. 5 -
6 mm between the chain bar and the cutter chain, the tension on the cutter
chain is adequate.
After adjusting the tension, tighten the hex bolt firmly to secure the chain bar.
Additionally tighten slightly the adjusting screw. Close the chain cover.
To remove the cutter chain, follow the installation procedures in reverse.
Securing tool to workpiece
006004
1
Loosen the vise lever and move the rear vise backward. Place the tool on the
workpiece so that the front vise contacts the side of the workpiece. Move the
rear vise forward until the distance between the rear vise and the workpiece is
3 - 8 mm. Tighten the vise lever to secure the rear vise. Move the tool so that
the "0" on the indication plate is aligned with the cutting line (A). Push the lever
(A) down fully to secure the workpiece.
006005
2