Related Manuals for Makita M908
Summary of Contents for Makita M908
- Page 1 INSTRUCTION MANUAL Angle Grinder M908 006770 DOUBLE INSULATION IMPORTANT: Read Before Using.
-
Page 2: Specifications
ENGLISH (Original instructions) SPECIFICATIONS Model M908 Depressed center wheel diameter 230 mm Spindle thread Rated speed (n)/No load speed (n 6,600 min Overall length 468 mm Net weight 4.8 kg Safety class • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. -
Page 3: Grinder Safety Warnings
Do not expose power tools to rain or wet Power tool use and care conditions. Water entering a power tool will 18. Do not force the power tool. Use the correct increase the risk of electric shock. power tool for your application. The correct Do not abuse the cord. - Page 4 and/or serious injury. may fly away and cause injury beyond immediate Operations such polishing area of operation. recommended to be performed with this power 10. Hold power tool insulated gripping tool. Operations for which the power tool was not surfaces only, when performing an operation where the cutting accessory may contact designed may create a hazard and cause personal injury.
- Page 5 forces, if proper precautions are taken. the possible kickback may propel the spinning b) Never place your hand near the rotating wheel and the power tool directly at you. accessory. Accessory may kickback over your c) When wheel is binding or when interrupting a hand.
-
Page 6: Functional Description
wheel breakage. WARNING: 20. Make sure the wheel is not contacting the DO NOT let comfort or familiarity with product workpiece before the switch is turned on. (gained from repeated use) replace strict adherence 21. Before using the tool on an actual workpiece, to safety rules for the subject product. - Page 7 For tool with the lock-off switch the operator. To prevent the switch trigger from accidentally pulled, a Mount the wheel guard with the protrusion on the wheel lock lever is provided. guard band aligned with the notch on the bearing box. To start the tool, push in the lock lever (in the A direction) Then rotate the wheel guard around 180 degrees and then pull the switch trigger (in the B direction).
-
Page 8: Operation
Installing or removing cut-off wheel Grinding and sanding operation ALWAYS hold the tool firmly with one hand on rear 1. Lock nut handle and the other on the side handle. Turn the tool on 2. Outer flange 78 and then apply the wheel or disc to the workpiece. 3. - Page 9 Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. Wheel guard (Wheel cover) • Inner flange • Depressed center wheels •...
- Page 12 Makita Corporation Anjo, Aichi, Japan www.makita.com 884637A9...