Operation - Makita CE002G Instruction Manual

To remove the wheel, press the shaft lock button and
rotate the wheel until the wheel cannot revolve. While
the shaft lock is fully locked, turn the hex bolt counter-
clockwise using the box wrench. Then remove the hex
bolt, flange, wheel, ring, and flange in order.
► Fig.8: 1. Shaft lock button 2. Box wrench 3. Tighten
4. Loosen
► Fig.9: 1. Hex bolt 2. Flange 3. Ring 4. Diamond
wheel 5. Arrow (rotation direction of the
wheel)
To install the wheel, follow the removal procedure in
reverse.
BE SURE TO TIGHTEN THE HEX BOLT SECURELY.
CAUTION:
Always install the wheel so that
the arrow on it points in the same direction as
the arrow on the wheel cover. Otherwise the wheel
rotates in reverse, it may cause personal injury.
CAUTION:
Only use the wheel that are
marked with a speed equal or higher than the
speed marked on the tool.
NOTE: When installing the wheel, be sure to attach
the flanges so that the flat side of flange faces the
wheel, and attach the ring that matches the inner
diameter of the wheel.
► Fig.10: 1. Hex bolt 2. Flange 3. Ring 4. Diamond
wheel
Connecting a vacuum cleaner
NOTICE:
Always close the cap when not con-
necting a vacuum cleaner.
When you wish to perform clean cutting operation,
connect a Makita vacuum cleaner to your tool.
Open the cap and connect a hose of the vacuum
cleaner.
► Fig.11: 1. Cap 2. Dust nozzle 3. Hose 4. Vacuum
cleaner
You can change the angle of the dust nozzle as shown
in the figure.
► Fig.12
Hose clamp
NOTICE:
Always remove the hose clamp from
the tool when not in use.
NOTICE:
Do not open or close the hose clamp
excessively. Otherwise the hose clamp may be
broken.
For easy handling of the hose of vacuum cleaner, hose
clamp can be attached
1.
Attach the hose clamp A or hose clamp B on the
hose.
Type
Hose clamp A
Hose clamp B
► Fig.13: 1. Hose clamp A / Hose clamp B 2. Hose
2. Insert the pins of hose clamp into the holes of
clamp holder.
Make sure the two pins are fit in the holes.
► Fig.14: 1. Pin 2. Hole 3. Clamp holder
3.
To remove the hose clamp, follow the installation
procedure in reverse.
Box wrench storage
When not in use, store the box wrench as shown in the
figure to keep it from being lost.
► Fig.15: 1. Box wrench

OPERATION

Checking the lower guard function
Remove the battery cartridge.
Retract the lower guard manually to the end and
release it. The lower guard is properly functioning if;
— it is retracted without any hindrance and;
— it automatically returns to the original position.
► Fig.16: 1. Lower guard
If the lower guard is not functioning properly, check if
dust is accumulated inside of the wheel cover.
Some dust may be removed by retracting and returning
the lower guard several times.
If the lower guard is not functioning properly even after
removing dust, have your machine serviced at a Makita
service center.
18 ENGLISH
Applicable outer diameter
of hose
ø 40 mm - ø 46 mm
(ø 1-9/16" - ø 1-13/16")
ø 35 mm - ø 40 mm
(ø 1-3/8" - ø 1-9/16")